Commercial & High-Rise Buildings

Commercial and high-rise buildings place transformers, feeders, electrical rooms and other building systems close to occupied spaces. C-INTECH uses field measurement, FEA modelling and project-specific engineering to assess low-frequency magnetic field concerns and RF conditions where applicable, then develop mitigation when required.

Common EMF Challenges in Commercial Buildings

Electrical infrastructure can create elevated low-frequency magnetic fields when major sources are located close to offices, residences and other occupied areas.

Transformer Rooms Near Occupied Areas: Power transformers and switchgear can produce elevated magnetic fields in spaces above, below or beside electrical rooms.
Electrical Risers & Distribution Systems: Bus ducts, feeders and other electrical distribution systems can affect nearby occupied spaces depending on load, routing and separation.
Tenant EMF Concerns: Measurements provide objective data when building occupants raise EMF questions or when EMF forms part of a workplace safety review.:
Building Renovations & Retrofits: Changes to equipment, feeder routes or room use can create new electrical adjacencies that should be evaluated before construction.
Solutions for Commercial Building Projects: We assess the source, expected field distribution, building geometry and project criteria before recommending a mitigation approach.
ELF Architectural Magnetic Shielding: FEA-informed shielding designed around the magnetic field source, building configuration, occupied space and required performance.
Active Field Mitigation Systems: Sensor-controlled compensation systems reduce low-frequency magnetic interference where passive shielding alone may not be practical.
EMF Surveys: On-site measurements establish actual magnetic field levels, identify sources and support decisions for existing buildings or renovations.
EMF Management Plans: Project-specific assessment, modelling and mitigation recommendations where municipal EMF planning requirements apply.

Projects We Support

C-INTECH supports new construction, renovations and existing facilities where electrical infrastructure may affect occupied or sensitive spaces.

Office Towers

Assess transformer rooms, risers, bus ducts and major feeders located near workspaces, tenant floors and amenity areas.

Condominium Buildings

Evaluate magnetic field conditions where residential units or shared spaces are located close to major electrical equipment.

Mixed-Use Developments

Address electrical-source adjacencies across residential, commercial, retail and shared building spaces during design or redevelopment.

Childcare Centres

Evaluate low-frequency magnetic fields where childcare spaces are located near building electrical systems or utility infrastructure.

Government Buildings

Support facility teams where occupancy, sensitive equipment or project criteria require EMF or RF assessment and mitigation.

Recent Commercial Building Project

Commercial building EMF concerns often depend on the location of electrical equipment relative to occupied areas. Early assessment can identify whether mitigation is required and where it should be applied.

Challenge

A transformer room was located directly below occupied space, creating concern about low-frequency magnetic field levels on the floor above.

Solution

C-INTECH developed a custom magnetic shielding system based on the field source, building geometry and required project performance.

Result

Verification measurements confirmed that field levels were reduced to the project requirements.

Why Building Owners & Engineers Choose Us

C-INTECH combines electromagnetic engineering, field measurement, modelling, shielding design and installation within one project team.

Engineering-Led Analysis

Field measurements and FEA modelling help define the source, field behaviour and appropriate response before mitigation is specified.

25+ Years of EMF/RF Experience

More than two decades of experience assessing and mitigating electromagnetic field concerns across buildings, infrastructure and sensitive environments.

Design Through Verification

C-INTECH supports projects from initial assessment and engineering through installation, calibration and post-installation performance verification.

Project-Specific Mitigation

Shielding and active mitigation systems are engineered around actual field conditions, building geometry and defined project requirements.

Discuss Your Project With Our Engineering Team

If your project includes electrical rooms, major feeders, sensitive occupancies or an existing EMF concern, C-INTECH can review the available drawings, field conditions and project criteria to determine the appropriate next step.

Related Services

Magnetic Field Analysis Studies

ELF Architectural Magnetic Shielding: Design & Installation

Electromagnetic Field (EMF) Surveys 

Why Choose us

Real People. Real Work. Real Rewards.

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.

Resource